How to Use a Printer Attached to a Windows XP Computer in Mac OS X Google translations: I’m not sure how good these automatic translations are. This document gives a detailed explanation of how to set up an HP DeskJet 722C printer that is attached to a Windows XP computer so that the printer can be used by a Mac OS X computer on a local area network (LAN). If your printer is slightly different, or you have a different version of Windows, or you’re using a different Unix than Mac OS X, or, you’ll have to adapt these instructions with your own creativity. Be aware that these procedures may not be necessary at all if the printer you have has Mac drivers, and other Microsoft incantations are working properly. Researchers anticipate Phase 2 will be completed in mid-2019. You may be able to get off easy, but then, you probably wouldn’t be searching the Internet looking for these instructions. Your mileage may vary. Thanks to the detailed directions at which gave me most of the information I needed to make these detailed instructions. The process falls into these five general steps: • On Windows: Make sure you have a set up on your Windows XP computer (this is not covered here). • On Windows: needed to emulate a Postscript printer and redirect printing ports • On Windows: Set up an on Windows XP that will actually print to the (probably non-Postscript) printer set up in step one. • On Windows: Set up on Windows XP that will point to the emulated Postscript printer in step three that in turn points to the real printer in step one. • On Mac OS X: Set up an printer in Mac OS X pointing to your Windows XP computer. What follows are some email messages that people have sent me about some problem they overcame that I did not encounter. I’m sorry I cannot “boil down” their advice, because I no longer have a PC, but here is what they have to say. Here’s an email someone sent me regarding using these instructions with Mac OS 9. There are a few reasons you might need to find your MAC address, also known as the physical address or hardware address. If you're setting up your router, for example, you could use MAC address. 2018-12-14 However, you might have the need to change the MAC address on a system. Here’s how to do it when you’re running Windows with an Intel Ethernet NIC. Steps to Change the MAC Address. The steps assume that you’ve already installed the Intel PROSet drivers for your Ethernet NIC. Another email from a user tells me that this work with Mac OS 8.6 too. To: Robert Harder From: Kevin Subject: Mac OS 9 is a very useful page. I was using it to set up my MacOs 9 to be able to print to the windows printer I have hanging off my windows xp machine. I had been using pcmaclan with windows 98. When I upgraded to windows xp, I saw from your page that I could set up a LPR printer, and no longer need pcmaclan (which understood appletalk packets). I could talk to the resulting tcp/ip printer directly. Password protect document in excel. So, knowing that I could setup MacOS 9 to talk to a tcp/ip printer, I thought it would be no problem following your page directions. I managed to get it to work, but not exactly as your page described. You describe creating 3 printers, right? Only two are needed. The LPR printer can use a RPT port (redmon) to send the ghostprint results directly to the windows printer. So only two printers are needed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |